Installation Guide

8
4. Attach a connector to side panel-1 by using a 1/4"x15 mm bolt and washer as shown in
Figure 4a. Guide the bolt through the hole in the connector, into the pre-drilled hole in the
side panel-1. Do not over tighten. Place the door onto the connector by guiding the pin in the
connector into the hole under the door. Then guide the pin on the other connector into the
hole in the top side of the door. Use a 1/4"x15 mm bolt and washer to secure the connector
to side panel-1 as shown in Figure 4b. Do not over tighten.
Figure 4a Figure 4b
5. With the help of another person, carefully place the firepit table rim onto the firepit base.
After making any necessary adjustments to the alignment of the table rim and the
assembled base, use four 1/4"x15 mm bolts and washers as shown in Figure 5. Guide the
bolts through the holes in the side panel brackets, into the predrilled holes in the table rim.
Hand tighten only.
Figure 5