Installation Guide

11
NATURAL GAS CONVERSION
Natural gas conversion must be performed only by your natural gas
provider or service company.
Step 1- At the control panel, disconnect the rubber gas hose from the gas valve.
Step 2- Below the burner, disconnect the aluminum gas tube from the orifice
elbow.
Step 3- Remove the 2 M4 nuts from the orifice holder and remove the orifice
bracket assembly.
Step 4- Disconnect the orifice from the elbow and replace it with the Natural Gas
orifice from the kit.
Re-fit the orifice bracket assembly onto the holder using the 2 M4 screws and nuts.
Re-connect the aluminum gas tube into the end of the elbow. Connect your
Natural Gas supply line onto the gas valve at the control panel. BEFORE
ATTEMPTING TO USE THE FIREPIT, check ALL of the connections for leaks
using a solution of soapy water. If a leak is discovered and any bubbles are seen,
close the main gas valve and re-tighten ALL the connections. NEVER USE A
FLAME TO CHECK FOR GAS LEAKS!