Instructions / Assembly

Page 4

ASSEMBLY INSTRUCTIONS

Place the table upside down on a flat, non-abrasive surface. Attach table leg to the table

rim by using the bolt and washer as shown in . Guide the bolt through the hole in the table leg, into

the pre-drilled hole in the table rim. Repeat for the other three legs.

rim (without glass) a

Fig 1

Hand tighten only 2-3 turns.

Attach a leg to the leg connector bracket by carefully guiding the bolts already in place on the table legs (each

leg has two bolts) through the holes in the leg connector bracket. Add a washer and a nut to the end of each

bolt as shown in . Repeat on the other three legs.Fig 2 Hand tighten only 2-3 turns..

After making any necessary adjustments to the alignment of the table, use the hex bolt driver and hex wrench to tighten

all bolts . each bolt must be tightened a few revolutions at a time. In order to apply equal pressure to all bolt

joints, we recommend working in a cross corner (X fashion). Repeat until all bolts are tight.

Over tightening may strip bolts. Cover all bolts with covers.

Note:

Do not over tighten.

FOOT CAP

With the help of another person, turn the table in the upright position. Note the clear bumpers spaced evenly throughout

the inside of the rim. Carefully place table glass inside the rim, resting on the clear bumpers.