Instructions / Assembly

ALF41515
Page 2
IMPORTANT!! PLEASE READ ENTIRE INSTRUCTION SHEET BEFORE ASSEMBLY!!
TO EXPEDITE ANY FUTURE WARRANTY CLAIMS, PLEASE KEEP INSTRUCTION SHEET, WARRANTY CARD AND RECEIPT
PARTS LIST DESCRIPTION ORDER PART #
QTY
1
1
A
B
C
D
E
F
G
H
I
J
K
16
1
BOLT COVER
HEX BOLT DRIVER
1/4" X 18 MM BOLT
TABLE LEG
LEG CONNECTOR
BRACKET
TABLE TOP
FC0069
HW0105
HW0004
HW0035
HW0014
HW0027
HW0009
HW0006
FOOT CAP
FACTORY ASSEMBLY
G0003
1
TOUCH-UP PAINT
4
8
8
NUT COVER
8
HEX WRENCH
1
1/4" NUT
8
Step 1: Remove all protective materials and set parts on a flat,
non-abrasive surface. Identify parts packed in carton
against the parts list. If you are missing any parts or are
unsure how to proceed with assembly, call our Customer
Service Center at 1-800-416-3511. Do not attempt
assembly if any parts are missing or damaged.
Fig.1
Step 2: Place the table top upside down on a flat, non-abrasive
surface. Attach a table leg to the table top by using the bolts
and washers as shown in . Guide bolts through holes in
the table legs and into the pre-drilled holes in the table top.
Hand tighten 2-3 turns only. Repeat for the other three legs.
Step 3: Attach a leg to the leg connector bracket by carefully
guiding the bolts already in place on the table legs
(each leg has two bolts) through the holes in the leg
connector bracket. Add a washer and a nut to the end
of each bolt Fig. . Hand tighten only.
Do not tighten completely. Repeat on the other three
legs.
as shown in 2
Step 4: After making any necessary adjustments to the
alignment of the table legs and the leg connector
bracket, use the hex bolt driver and hex wrench to
tighten all nuts and bolts. Note: each bolt and nut
must be tightened a few revolutions at a time. In
order to apply equal pressure to all bolt joints, we
recommend working in a cross corner (X fashion).
Repeat until all bolts are tight. Do not over tighten.
Over tightening may strip bolts. Cover all nuts and
bolts with covers.
Step 5: With the help of another person, turn the table in the
upright position. Your table is now ready for use. If
you have any questions, please call our Customer
Service Center at 1-800-416-3511.
IMPORTANT NOTE: Damage to welds or frames
resulting from over tightened bolts or improper assembly
is not covered under our warranty. Please read all
instructions carefully before assembly. If you have any
questions regarding your assembly, call our Customer
Service Center at 1-800-416-3511.
* NOTE: PARTS SHOWN ON PARTS LIST ARE NOT TO SCALE
Ø6.5 X 1.0 MM
WASHER
Fig.1
Fig.2
UMBRELLA HOLE
PROTECTIVE
RING (SET)
FACTORY ASSEMBLY
G0235 & G0236
FOOT CAP
A
E
G
H
B
F
E
D
C
UMBRELLA POLE
STOPPER & NUT
FACTORY ASSEMBLY
G0091
& HW0448