Installation Instructions / Warranty Retroaktiv 06127XX0 Retroaktiv 06126XX0 Retroaktiv 06397XX0
Retroaktiv Showerheads and Handshower Spray modes: full spray Turbo3 massage Flow rate 2.5 gpm Spray modes: full spray Turbo3 massage Flow rate 2.5 gpm Spray modes: full spray Flow rate 2.
Showerhead Installation Remove the old showerhead: While holding the shower arm, remove the existing showerhead by turning counter-clockwise with a wrench. Clean the threads on the shower arm with a wire brush. Install the new showerhead: Slide the boot onto the shower arm. Push it out of the way. Screw the showerhead onto the arm by hand. Finish tightening with a wrench, if desired. Turn on the water and check for leaks. Pull the boot down over the joint. Note: Retroaktiv 06397XX0 does not include a boot.
If the flow of water becomes noticeably less, remove and clean the screen washer. User Instructions Change the spray mode - models 06126XX0 and 06127XX0 only Push the selector lever until the indicator mark is next to the name of the desired spray function. There are two spray modes: full spray and Turbo3 massage.
If scale deposits are noticed on the spray face, pour about 3/4” of a commercial scale remover, such as Lime-AwayTM or CLRTM ,into a shallow dish. Dilute the remover according to the label instructions. Soak only the spray face in the solution for the amount of time specified on the label. Rinse the showerhead/handshower with clear water. Reinstall the showerhead/handshower. Turn on the water and allow it to flush for at least one minute.
Cleaning Recommendation for Hansgrohe Products Modern faucetry and shower products utilize a combination of materials to comply with the needs of the market with regard to design and functionality. To avoid damage, it is necessary to use some caution when cleaning. Damage caused by improper treatment is not covered under the Hansgrohe warranty. Cleaning Materials for Faucets and Showers • • • • To remove lime scale, use only products made specifically for that purpose.
THIS WARRANTY DOES NOT COVER, AND HANSGROHE WILL NOT PAY FOR: A. Conditions, malfunctions or damage not resulting from defects in material or workmanship. B. Conditions, malfunctions or damage resulting from (1) improper installation, improper maintenance, misuse, abuse, negligence, accident or alteration, or (2) the use of abrasive or caustic cleaning agents or “no rinse” cleaning products, or the use of the product in any manner contrary to the product instructions. C.
www.hansgrohe-USA.com US - Installation Instructions • Part No. 90965401-03 • Revised 04/2007 Hansgrohe, Inc. • 1490 Bluegrass Lakes Parkway • Alpharetta, GA 30004 Tel.
