Installation Instructions / Warranty Accessories C 06090xx0 Accessories C 06091xx0 Accessories C 06092xx0 Accessories C 06093xx0 Accessories C 06094xx0 Accessories C 06095xx0 Accessories C 06096xx0 06099xx0 Accessories C 06097xx0 06098xx0 Accessories E 06589xx0 Accessories E 06592xx0 Accessories E 06593xx0 Accessories E 06596xx0 Accessories E 06600xx0 Accessories E 06594xx0 06595xx0 Accessories E 06598xx0 06866xx0 Accessories S 04063xx0
Accessories C, Accessories S 2½" 7⅝" 2½" 2½" 2" 7" 3" 1⅛" 2½" 2½" 4⅛" 4½" 5⅛" ½" 2⅞" 06091xx0 Soap Dish 06090xx0 Tumbler 06095xx0 Towel Ring 1⅛" 06092xx0 Soap Dispenser 1⅝" 14⅛" 1⁹⁄₁₆" 2½" 2⅞" 2⁹⁄₁₆" 5⅛" 06096xx0 Face Cloth Hook 06099xx0 Robe Hook 06093xx0 Toilet Paper Holder 06094xx0 Toilet Brush 13⅝" 2" ⁹⁄₁₆" 2½" 11" ⁹⁄₁₆" 2" 2½" 26⅛" 2" 2½" 2 ⁹⁄₁₆" 23⅝" 06097xx0 26⅛" 12” Towel Bar 06098xx0 24” Towel Bar 23⅝" 04063xx0 Toilet Paper Holder
Installation 06092xx0, 06091xx0, 06090xx0, 06093xx0, 06094xx0, 06095xx0, 06097xx0 / 06098xx0, 04063xx0 Using the mounting piece as a template, mark the positions of the screw holes. Do not press the mounting piece into the accessory until the mounting piece is screwed firmly to the wall! Drill the holes with a 6mm bit. Install the anchors. If the accessory is installed in the shower, seal the wall around the anchors with waterproof sealant. Failure to seal the wall can lead to possible water damage.
06097 Towel bar only: Press the end pieces over the mounting pieces (1). Use the enclosed allen wrench to tighten the set screws (2) Other accessories and towel bars: Press the accessory firmly over the mounting piece. The retaining pin in the accessory will snap into place, holding the accessory firmly on the mounting piece. To remove the accessory from the wall 06097 Towel bar only: Use the allen wrench to loosen the set screw (1). Pull the accessory away from the wall (2).
Installation 06096xx0, 06099xx0 Drill the hole using a 6 mm bit suitable for the wall surface. Install the anchor. If the accessory is installed in the shower, seal the wall around the anchors with waterproof sealant. Failure to seal the wall can lead to possible water damage. Screw the mounting piece to the wall. Screw the hook to the mounting piece.
Accessories E Soap Dispenser 06593xx0 Soap Dish 06592xx0 Tumbler 06589xx0 Toilet Paper Holder 06596xx0 24” Towel Bar 06866xx0 Toilet Brush 06600xx0 12” Towel Bar 06598xx0 Robe Hook 06595xx0 Face Cloth Hook 06594xx0 Installation 06593xx0, 06589xx0, 06592xx0, 06600xx0 Mark the positions of the screw holes on the wall. Drill the screw holes using a 6 mm drill bit. If the accessory is installed in the shower, seal the wall around the anchors with waterproof sealant.
Screw the support into the anchors. The pin on the support should be on the bottom. Slide the cover over the support. The pin on the support clicks into place in the hole in the cover. Place the accessory into the holder. The accessory may be removed from the holder. Installation 06596xx0 Mark the positions of the screw holes. Drill the screw holes using a 6 mm bit suitable for the wall surface. Install the anchors.
Installation 06594xx0, 06595xx0 Mark the positions of the screw holes on the wall. Drill the screw holes with a 6 mm drill bit Install the anchors. If the accessory is installed in the shower, seal the wall around the anchors with waterproof sealant. Failure to seal the wall can lead to possible water damage. Screw the hook into the wall. Slide the screw cover against the wall. Installation 06598xx0, 06866xx0 Mark the positions of the screw holes. Drill the holes using a 6 mm drill bit.
Install the anchors. If the accessory is installed in the shower, seal the wall around the anchors with waterproof sealant. Failure to seal the wall can lead to possible water damage. Screw the towel bar into the anchors. Slide the escutcheon over the screws. Fill soap dispenser 06593xx0, 06092000 Lift the pump assembly off the bottle. Fill the bottle. Replace the pump assembly.
Replacement Parts - Accessories C 4 3 7 5 1 9 6 8 2 Replacement Parts — Accessories E 3 4 12 9 5 10 6 8 7 2 11 1 2 3 4 5 6 7 8 9 10 11 12 10 mounting piece mounting set soap dish tumbler pump bottle cup brush head brush holder cover mounting & support kit 96341000 40915000 40936000 40935000 40918000 40299000 40086000 40088000 40089xx0 40215000 96110xx0 40292xx0 xx = color 00 = chrome 62 = oil rubbed bronze 82 = brushed nickel 83 = polished nickel
Cleaning Recommendation for Hansgrohe Products Modern bathroom faucets, kitchen faucets and shower products are made from different materials to comply with the needs of the market with regard to design and functionality. To avoid damage to the product, it is necessary to take proper care of it. For best results: • Prevent the buildup of mineral scale and /or soap residue by cleaning your Hansgrohe product(s) when needed. • • Select a cleaning agent specifically intended for the type of product.
maintenance, misuse, abuse, negligence, accident or alteration; (2) the use of abrasive or caustic cleaning agents or “no-rinse” cleaning products, or the use of the product in any manner contrary to the product instructions; or (3) conditions in the home such as excessive water pressure or corrosion. C.