Installation Guide

7
Installation 06596xx0
Mark the positions of the screw holes.
Drill the screw holes using a 6 mm bit suitable for the
wall surface.
Install the anchors.
Screw the support into the anchors. The pin on the sup-
port should be on the bottom.
Slide the cover over the support. The pin on the support
clicks into place in the hole in the cover.
Place the accessory into the holder.
The accessory may be removed from the holder.
Screw the support into the anchors.
Slide the toilet paper holder over the support.
If the accessory is installed in the
shower, seal the wall around the an-
chors with waterproof sealant.
Failure to seal the wall can lead to
possible water damage.