Product Manual

Hanshow ESL Controller HS_C09978 Product Manual
21 Hanshow Copyright Reserved ©
Hanshow Technology Co., Ltd.
5 Workflow
To ensure that Wi-Fi AP works normally before HS_C09978 powered-on. Specifically,
the workflow of USB integration AP is as shown in Figure 5-1.
Circuit check
Integration AP powered -on
Wi-Fi AP runs normally
Association
parameter settings
HS_C09978 powered-on
Integration AP running
HS_C09978
configuration
HS_C09978 running
Figure 5-1 Wi-Fi AP workflow
Follow the steps:
1. Before starting HS_C09978, check if the USB interface of Wi-Fi AP meets
5V/500mA and USB 2.0 and higher, and the system is whether to support USB
virtual network port.
2. Check if power cable and network cable are connected properly.
3. HS_C09978 device does not start until the Wi-Fi AP is officially started (about 5min).
4. HS_C09978 startup takes about 1min. After the system startup is complete, the LED
indicators turn green that indicates working status.
5. Follow the section of 4.2 to configure the relevant parameters accordingly.