User's Manual

Parts 3

Connection to Signal Source 4

the range of control Angle 5

Installing Monitor Driver 6

Name and Function of Front 8

Power Management Feature 10

Adjusting OSD 11

Standard Signal Table

Specification

Troubleshooting 20

Warning 22

Table of Contents

INFORMATION TO USER :

This equipment has been tested and found to comply with the limits of a Class

B digital device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful

interference in a residential installation.This equipment generates, uses and can

radiate radio frequency energy and,if not installed and used in accordance with

the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular

installation; if this equipment does cause harmful interference to radio or

television reception, which can be determined by determined by turning the

equipment off and on, the user is encouraged to try to crrent the interference by

one or more of the fllowing measures:

1. Reorient/Relocate the receiving antenna.

2. Increase the separation between the equipment and receiver.

3. Connect the equipment into an outlet on a circuit difference

from that to which the recerver is connected.

4. Consult the dealer or an experienced radio/TV technician for help.

CAUTION

Changes or modifications not expressly approved by the

manufacturer responsible for compliance could void the user's

authority to operate the equipment

ENERGY STAR

As an ENERGY STAR partner, Hansol Electronics Inc.

has determined that this product meets energy Star guidelines

for energy efficiency.