User s Manual TFT-LCD Color Monitor H750V(B17AC) / H950V(B19AC) Printed on the recyclable paper Printed in Thailand Part No.
INFORMATION TO USER : This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.This equipment generates, uses and can radiate radio frequency energy and,if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Good Posture Guide Parts Place the monitor to face the user and then adjust the monitor angle. Take a break (for about 10 minutes) at every hour during the work with monitor. Refer to the following figure to take the correct posture. about 50cm Look down the monitor below the horizon. Adjust the monitor to prevent reflection. 17 " LCD Monitor 19 " LCD Monitor Relax shoulders and arms, and sit back on the chair. Adjust the monitor stand to acquire required angle.
Connection to Signal Source Basic Connection The range of control Angle How to Adjust the Stand Port for AC power cable. Port for BNC output Port for BNC input Port for S-VHS input Port for Audio input Kensington Lock Port for signal cable from signal source. Forward 3 < Power source connection > < Signal cable connection> General For Macintosh Default Adapter for Macintosh (Optional) Refer to the table on the rear side of the optional Macintosh adapter and adjust DIP switch by the resolution. 1.
Name and Function of Front Front panel Functions Power button Power button is located in the lower center of the Front Bezel. You can push the button to turn on/off the power. Power Indicating LED Dark : Power off Green : Normal mode Green blinking : DPMS mode or Check Signal Cable mode. 17 " LCD Monitor 19 " LCD Monitor On Screen Display (OSD) Function Button OSD buttons on the front of bezel perform the following functions.
Power Management Feature The monitor is equipped with a power saving circuit that confirms to the world-standard Display Power Manager Signalling (DPMS) mode of Video Electronics Standard Association (VESA). The power management feature requires that the video card of the computer should support DPMS function. Status LED Sign Power Consumption Normal mode Green ON Normal Power DPMS mode Green Blinking 3W or Below DPMS with Audio Adjusting OSD -P C M O D E Brightness / Contrast MENU SELECT 1.
Clock Phase Phase SELECT MENU 1. Press the MENU button to access main menu. 2. Use to move CLOCK PHASE ICON. 3. Press SELECT button into the submenu. SELECT to move Phase ICON. 1. Press 2. Use SELECT button to select it. 3. Use to correct fine trembling or Video noise. Horizontal Position Clock SELECT 1. Use to move H-Position ICON. 2. Press SELECT button to select it. 3. Use to adjust display left or right. According to the characteristic of video card, control range can be changed.
OSD H-Position Preset Color MENU SELECT 1. Use to select the Mode 1, and Mode 2. 2. Press the Menu button to return previous state. 9300K : Slightly Bluish white. 6500K : Slightly Reddish white. OSD V-Position User Color SELECT MENU 1. Use to move User color ICON. 2. Press SELECT button to select it. 3. Use to increase or decrease each color. OSD MENU SELECT 1. Use to move OSD V-Position ICON. 2. Press SELECT button to select it. 3. Use to adjust OSD upward or downward. OSD Time SELECT 1.
Special MENU SELECT 1. Press the MENU button to access main menu. 2. Use to move Special ICON. 3. Press SELECT button into the submenu. Auto-Config Information MENU SELECT 1. Use to move the Information ICON. 2. Press SELECT button to select it. You can know display information Accoding to the characteristic of video card, display information can be incorrect Language MENU Auto-Config Sound SELECT MENU 1. Use to move Language ICON. 2. Press SELECT button to select it. 3. Use to select language.
Adjusting OSD -CVBS, SVIDEO MODE Brightness / Contrast MENU Sharpness (CVBS,SVIDEO Mode) SELECT SELECT 1. Press the MENU button to access main menu. 2. Use to move Brightness / Contrast ICON. 3. Press SELECT button into the submenu. 1. Press the MENU button to access main menu. 2. Use to move Sharpness ICON. 3. Press SELECT button to select it. 4. Use to adjust the sharpness. (Adjust the clearness of the screen) Color Brightness SELECT 1. Use to move Brightness ICON. 2.
Saturation OSD H-Position SELECT SELECT 1. Use to select the Saturation ICON. 2. Press SELECT button to select it. 3. Use to adjust the saturation. Preset Color 1. Use to move OSD H-Position ICON. 2. Press SELECT button to select it. 3. Use to adjust OSD left or right. OSD V-Position MENU SELECT 1. Use to select the Mode 1, and Mode 2. 2. Press the Menu button to return previous state. 9300K : Slightly Bluish white. 6500K : Slightly Reddish white. OSD MENU OSD Time SELECT 1.
Auto-Config Information Special MENU SELECT 1. Press the MENU button to access main menu. 2. Use to move Special ICON. 3. Press SELECT button into the submenu. MENU SELECT 1. Use to move the Information ICON. 2. Press SELECT button to select it. You can know display information Accoding to the characteristic of video card, display information can be incorrect Language Auto-Config Sound MENU SELECT 1. Use to move Language ICON. 2. Press SELECT button to select it. 3. Use to select language.
Standard Signal Table Pin assignment table D-Sub Mini 15pin connector PC Supported Mode Resolution Horizontal Frequency (KHz) Vertical Frequency (Hz) Clock Frequency (MHz) VGA (720 X 400) 31.469 70.087 28.322 VGA (640 X 480) 31.469 59.940 25.175 VGA (640 X 480) 37.500 75.000 31.500 SVGA (800 X 600) 37.900 60.320 40.000 SVGA (800 X 600) 46.875 75.000 49.500 XGA (1024 X 768) 48.363 60.004 65.000 XGA (1024 X 768) 60.023 75.029 78.750 SXGA (1280 X 1024) 63.981 60.020 108.
Specification Model LCD Panel H750V(B17AC Amorphous active matrix super TFT LCD Type Amorphous active matrix super TFT LCD 43.2cm (Diagonal) Screen Size 48.3cm (Diagonal) Maximum Resolution 1280 X 1024 @ 75 Hz Maximum Resolution 1280 X 1024 @ 75 Hz Pixel Range 0.264 mm X 0.264 mm Pixel Range 0.294 mm X 0.294 mm Display Colors 16.7M Color Display Colors 16.
Troubleshooting Power LED is dark. No picture. Check the power connection. (Refer to page 4) Color is irregular. Adjust COLOR at User Mode in OSD Color Menu. OSD, "check RGB ( CVBS, SVIDEO)" is displayed on the screen. Check the signal cable or signal Source. (Refer to page 4) Double images or 'ghosts'. Check the resolution and frequency of computer and video card, and set up again in reference to the current monitor mode and standard signal mode table. Screen looks to be run down.
Warning To prevent damage or loss, please read this warning carefully. When connecting/disconnecting the plug, pull out the plug itself, and never pull the cord to prevent fire caused by short. To prevent electric shock, do not connect/disconnect the plug with wet hand. If you see smoke or smell something burning, stop using the unit, switch off the power, pull out the plug, and then contact your local service station. To prevent fire, do not connect a large number of equipments in a single line.
