User's Manual

ManualsBrandsHansong Technology ManualsAudio EquipmentWi-Fi Speaker

Aiplay Unit User Manual

LED status and Description

LED Color Description

Solid Red

The unit is in power off state. No Audio can be played.

Blinking Blue When the power button is pressed the led will blink.

This indicates that the system is starting.

Solid Blue This indicates that the system has connected with

WI-FI router.

Solid Purple The system will get into power save mode if there is no

operation on it ,and LED will become solid purple

Summary of content (8 pages)

PAGE 1
Aiplay Unit User Manual LED status and Description LED Color Description Solid Red The unit is in power off state. No Audio can be played. Blinking Blue When the power button is pressed the led will blink. This indicates that the system is starting. Solid Blue This indicates that the system has connected with WI-FI router.
PAGE 2
LED Color Description Solid Green When the adaptor is plugged in and the unit is in charging mode.
PAGE 3
without entering any password/pass key information. Source Button ·. If you plug in aux cable and play back, and now unit in airplay mode, Press the Source button on side of the unit it can change to MP3 mode . Battery off ·. If software crashes, firstly pull out the adaptor, then you should stab the key with pointed things for more than 3 seconds, later you can power on it again.
PAGE 4
network. ·You are know ready to use the Airplay ② Log share network setup ·Press the Power button on the side of the unit ·The indicator light above the “Vol-“ button will flash rapidly to indicate that the unit is starting up . When the indicator light starts to flash slowly move on to the next step. ·Plug in the Ipad or Iphone by Docket or USB, Press WPS button short, and then you should see a popup window means that do you want to share the wi-fi setup and let the accessories access the wi-fi network.
PAGE 5
③ JB direct connect setup ·Press the Power button on the side of the unit ·Press the WPS button until the led blinking rapidly. ·Turn on the WIFI from your apple device,and you will find the unit name.Connect it and you can playback the music by airplay unit. Audio playback function setup ① MP3 playback setup ·Press the Power button on the side of the unit ·The indicator light above the Vol- button will flash rapidly to indicate that the unit is starting up .
PAGE 6
② Docket playback setup ·Press the Power button on the side of the unit ·The indicator light above the Vol- button will flash rapidly to indicate that the unit is starting up . When the indicator light starts to flash slowly ,put ipad or iphone plug to the docket, and then play the ipod music you can listen to the music. ③ Airplay playback setup ·Press the Power button on the side of the unit ·The indicator light above the Vol- button will flash rapidly to indicate that the unit is starting up .
PAGE 7
Caution: This device complies with Part 15 of the FCC Rules / Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
PAGE 8
d'antenne et son gain de sorte que la puissance isotrope rayonnée équivalente (p.i.r.e.) ne dépasse pas l'intensité nécessaire à l'établissement d'une communication satisfaisante. MPE Reminding To satisfy FCC / IC RF exposure requirements, a separation distance of 20 cm or more should be maintained between the antenna of this device and persons during device operation. To ensure compliance, operations at closer than this distance is not recommended.