User's Manual

Compliance
FCC Statement
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part
15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
Interference to radio communications. However, there is
no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one of the
following measures:
- Reorient or relocate the equipment.
-Connect the equipment to an outlet on a circuit different
from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician
for help
FCC Caution
Any changes or modifications not expressly approved by
the party responsible for compliance could void the user’s
authority to operate this equipment.
17
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation.
Cet appareil est conforme à la section 15 des
réglementations wwde la FCC. Le fonctionnement de
l’appareil est sujetaux deux conditions suivantes :
(1) cet appareil ne doit pas provoquer d’interférences
néfastes, et (2) cet appareil doit tolérer les interférences
reçues, y compris celles qui risquent de provoquer un
fonctionnement indésirable.
This device and its antenna must NOT be co-located or
used in conjunction with any other antenna or transmitter.
Important note: Radiation exposure statement. This EUT is
compliant with SAR for general population / uncontrolled
exposure limits in ANSI/IEEE C95.1-1999 and has been
tested in accordance with the measurement methods and
procedures specified in OET bulletin 65 supplement C.
To satisfy FCC / IC RF exposure requirements, a separation
distance of 20 cm or more should be maintained between
the antenna of this device and persons during device
operation. To ensure compliance, operations at closer than
this distance is not recommended.