User Manual


DSO1000 SERIES
Figure 2-5 Waveform Display
3. Set Probe Attenuation
The ll allows adjusting the probe attenuation scale factor correspondingly
in the channel operation menu in order to comply with the probe attenuation scale.
The attenuation factor changes the vertical scaling of the ll so that the
measurement results reect the actual voltage levels at the probe tip.
To change (or check) the probe attenuation setting, press the CH1 or CH2 button
(according to which channel in using). Toggle the Probe soft button to match the
attenuation factor of the probe.
This setting remains in effect until changes again.
Figure 2-6 Probe Setting
HANDHELD OSCILLOSOPE