User Manual
Table Of Contents
- Copyright Declaration
- General Safety Summary
- Safety Terms and Symbols
- Product Scrapping
- Contents
- DSO2000 series digital storage oscilloscope introduction
- 1. Quick start
- 2. Function Introduction
- 2.1. Menu and Control Keys
- 2.2. Connector
- 2.3. Multi-function Knobs and Softkeys
- 2.4. Oscilloscope Setup
- 2.5. Horizontal Controls
- 2.6. Vertical System
- 2.7. Trigger System
- 2.8. Protocol Decode
- 2.9. Save/Recall
- 2.10. Measure System
- 2.11. DVM
- 2.12. Acquire
- 2.13. Display
- 2.14. Utility System
- 2.15. Fast Action Buttons
- 3. Waveform Generator
- 4. Remote Control
- 5. Troubleshooting
- 6. Services and Support
- 7. General Care and Cleaning
- Appendix A: Technical Specifications
- Appendix B: Accessories
- Appendix C Harmful and Poisonous Substances or Elements
User Manual
63 / 72
Click "Interactive IO", send an instruction arbitrarily, and the computer and the oscilloscope will
communicate.
Double-click to open the host computer software, and "Connected" is displayed in the lower left corner
of the interface. At this point, the host computer has been connected.
5. Troubleshooting
1. If the oscilloscope does not start up at power on, follow these steps:
1) Check the power cord to verify it has been connected properly;
2) Check the power on/off button to ensure it has been pushed;
3) Then restart the oscilloscope.
Contact your local HANTEK distributor or directly keep touch with HANTEK Technical Support
department if the oscilloscope still can not be turned on normally.