User's Manual

Reset the terminal back to the initial service status of factory pre-programmed state.
This feature can be disabled and enabled through simple keypad number code entry.
1. Pick up the handset.
2. Press <*( ) >, <*( ) > and <10>.
3. Press 4 digits Lock Code Number. (The default lock code is preset to 0000 at the
factory.)
NOTE : If the code is correct, it will confirm with a tone.
If not, it returns to the stand by mode with error beep.
4. Press <*( ) >.
5. Wait until you hear confirmation tone.
4.8 Reset
Using RS-232 Data Cable , you can connect this model to PC for Internet,
if your service provider provides Wireless Data Communication Service.
1.In case DS(Data Service) mode
- Press "36*#102*" to DS mode
2.In case DM(Diag. Monitor) mode
- Press "36*#101*" to DM mode
4.9 Auto Dial time
4.10 Data service
You can set Auto Dial time(0sec ~ 9sec) on your phone. Default setting is 5sec.
1. Pick up the handset.
2. Press <*( )>, <*( )> and <11>.
3. Press Auto dial time(0~9).
4. Press <*( )>.
5. Wait until you hear confirmation tone.