User's Manual

configure settings
18_ configure settings
Change Module
You can switch the position between jog shuttle and joystick from left to right or vice versa.
1. Select the <Change Module> menu.
2. You can check that the power is turned off
and switch the jog shuttle position with the
joy stick by pressing the <Exit> button.
3. Check the current setting, press <Cancel>.
NETWORK
Configures the network connection type and environment.
•
IP type : Selects the type of network connection.
•
IP address : Subnet, Gateway, DNS
If connection is <Static> : You can enter the IP
address, subnet, gateway and DNS directly.
If connection is <DHCP> : IP address, subnet and
gateway are configured automatically.
M
`
If you set the DNS mode manually, you can enter
the DNS IP information directly.
SYSTEM ENVIRONMENT
You can update the current firmware using the firmware files in the USB memory.
To update the controller firmware
You can download the latest firmware files and update the controller.
1. Connect a USB memory device on which
new firmware is stored to the network
controller.
2.
From the menu setup screen, press <System>.
3. Press <Update firmware>.
4. In the Update window, press the <OK>
button.
5. Wait until the system restarts after the update.
M
`
Do not disconnect the USB memory or power cable during the update. Otherwise, it may fail to update the
firmware or cause a system failure.
Factory Reset
You can return the current settings to the factory default.
1.
Press <Factory Reset>.
2. Press <Reset>.
The current settings will return to the factory
default.
3. To exit the menu, press <Cancel>.