User Manual
Table Of Contents
- overview
- One-way camera
- LED parking indicator light
- installation & connection
- network connection and setup
- Connecting the Camera Directly to Local Area Networking
- Connecting the Camera Directly to a DHCP Based DSL/Cable Modem
- Using Device Manager
- Automatically searching camera
- Configuring IP address
- Manually registering camera
- Automatically configuring IP
- Port Range Forward (Port Mapping) Setup
- Connecting to the Camera from a Shared Local PC
- Connecting to the Camera from a Remote PC via the Internet
- web viewer
- appendix
English _13
! ONE-WAY CAMERA
3. Remove the body protection cover by turning the 2 fixing screws on both sides of the body protection
cover counterclockwise with the provided Torx L wrench.
`
If it is difficult to separate the cover, check if the 4 fixing screws for the body protection cover are loosened.
`
It is not required to completely remove screws from the cover.
TR20
2x
4. Lift the mount plate obliquely and then pull it out.
`
Check the 2 fastening screws on the camera body are loosened.
Inserting a Micro SD card
Insert the micro SD card into the micro SD card slot on the camera body in the arrow direction.
J
`
Before installing the camera, the Micro SD card should be inserted while the power source and the body are separated.
`
Do not forcefully insert it in the reverse direction. It might damage your Micro SD card and your product.
`
When it rains or the humidity is high, insertion or ejection of a Micro SD card is not recommended.
`
Disassembly of the product cover should be finished within 5 minutes, or there will be the risk of internal dew condensation.