User Manual
Table Of Contents
- overview
- One-way camera
- LED parking indicator light
- installation & connection
- network connection and setup
- Connecting the Camera Directly to Local Area Networking
- Connecting the Camera Directly to a DHCP Based DSL/Cable Modem
- Using Device Manager
- Automatically searching camera
- Configuring IP address
- Manually registering camera
- Automatically configuring IP
- Port Range Forward (Port Mapping) Setup
- Connecting to the Camera from a Shared Local PC
- Connecting to the Camera from a Remote PC via the Internet
- web viewer
- appendix
English _19
! ONE-WAY CAMERA
Outdoor installation
When you install the camera outdoors, it should be waterproofed with waterproof butyl rubber tape (which
can be purchased in stores) so that water does not leak from the gap of the cable connected in the outdoor
area.
1. Connect the power, audio I/O and LAN cables.
2. Wrap the black cable jacket (Area A) and the cable connection
area with waterproof (butyl rubber) tape so that more than half of
the butyl rubber tape is overlapped.
J
`
If the cable jacket is not waterproofed properly, then it can directly cause
leakage. Make sure to protect the cable with a dense layer of taping.
`
Waterproof butyl tape is made of butyl rubber that can be stretched to
twice its normal length.
Adjusting the monitoring direction for the camera
`
Adjusting the monitoring direction
While the camera is fixed to the structure, adjust the direction of the camera.
Tilt is to adjust the gradient of the lens.
- You can tilt the camera angle from 55° to 80°.
`
Methods of adjustment
Grab the lens holder and then adjust the tilting angle in the direction to monitor.
J
`
To adjust the camera monitoring direction, grab the lens holder and turn it.
If you grab the lens to adjust the direction, the focus could be out or fingerprints could remain on the surface.