User Manual
Table Of Contents
- overview
- One-way camera
- LED parking indicator light
- installation & connection
- network connection and setup
- Connecting the Camera Directly to Local Area Networking
- Connecting the Camera Directly to a DHCP Based DSL/Cable Modem
- Using Device Manager
- Automatically searching camera
- Configuring IP address
- Manually registering camera
- Automatically configuring IP
- Port Range Forward (Port Mapping) Setup
- Connecting to the Camera from a Shared Local PC
- Connecting to the Camera from a Remote PC via the Internet
- web viewer
- appendix
English _23
! LED PARKING INDICATOR LIGHT
3. Remove the body protection cover by turning the 2 fixing screws on both sides of the body protection
cover counterclockwise with the provided Torx L wrench.
`
If it is difficult to separate the cover, check if the 4 fixing screws for the body protection cover are loosened.
`
It is not required to completely remove screws from the cover.
2x
TR20
4. Lift the parking indicator light module obliquely and then pull it out.
`
Check the 2 fastening screws on the parking indicator light module are loosened.
Installing on the raceway (mount plate)
1. On the raceway, mark the place where the provided raceway mounting adapter is to be inserted, and then
drill a hole for it.
ø30
2. Fix the mounting adapter to the mount plate with the provided 2 screws.