User Manual
Table Of Contents
- overview
- One-way camera
- LED parking indicator light
- installation & connection
- network connection and setup
- Connecting the Camera Directly to Local Area Networking
- Connecting the Camera Directly to a DHCP Based DSL/Cable Modem
- Using Device Manager
- Automatically searching camera
- Configuring IP address
- Manually registering camera
- Automatically configuring IP
- Port Range Forward (Port Mapping) Setup
- Connecting to the Camera from a Shared Local PC
- Connecting to the Camera from a Remote PC via the Internet
- web viewer
- appendix
LED parking indicator light
26_ LED parking indicator light
5. Insert the cable bushing of the network cable into the parking indicator light module.
6. Connect the connector of the network cable to the PoE port of the parking indicator light module.
[Installing the power cable (for use of DC power)]
7. Remove the cable bushing on the power port (DC 12 V) from the parking indicator light module.
8. Remove the protruding part on the removed cable bushing.
9. Pass the power cable through the cable bushing and then connect the provided power terminal block.
Power terminal block