User Manual
Table Of Contents
- overview
- One-way camera
- LED parking indicator light
- installation & connection
- network connection and setup
- Connecting the Camera Directly to Local Area Networking
- Connecting the Camera Directly to a DHCP Based DSL/Cable Modem
- Using Device Manager
- Automatically searching camera
- Configuring IP address
- Manually registering camera
- Automatically configuring IP
- Port Range Forward (Port Mapping) Setup
- Connecting to the Camera from a Shared Local PC
- Connecting to the Camera from a Remote PC via the Internet
- web viewer
- appendix
installation & connection
32_ installation & connection
Connecting to the I/O port box (MGC-D8080LI/MGC-D8080)
Connect the Alarm I/O cable to the corresponding port of the port box.
Alarm Sensor
Alarm-related Connector
J
`
Make sure to connect the provided audio/alarm/power cable before use.
Color Function Description
BLUE : ALARM #1
BROWN : ALARM #2
ALARM I/O 1,
ALARM I/O 2
These two ports are configurable from the web viewer, as they can be
used as Alarm in or Alarm out
※
Alarm I/O changes can be made through the Webviewer setup.
BLACK GND It is a ground terminal.
To connect to an external sensor
To use as an Alarm IN: Connect one of the [ALARM I/O] port and the other terminal to the [GND] port.
Alarm In Wiring Diagram(example)
Sensor
External connection
ALARM #1
ALARM #2
GND
Alarm cable
<If ALARM I/O 1 is set as an input terminal>
To connect to an alarm output
If devices (e.g., flashing light and siren) that exceed the voltage and current specifications are connected by
using the open collector method, it may cause damage.
Refer to the alarm out connection diagram below case.
Alarm Out Wiring Diagram(example)
ALARM
POWER
ALARM
RESISTOR
DIODE
RELAY
VCC
GND
TRANSISTOR
External connectionAlarm cable
ALARM #1
ALARM #2
GND
<If ALARM I/O 1 is set as an output terminal>