Installation Instructions

● basic setup method I
-Using main controller, connecting general conference system
- setting procedure
1. Place Main controller KMC-200 to proper plane location ( ; Install to Rack Cabinet)
2. Connect power adaptor cable to power port in rear side
3. Connect external audio device to Audio Out terminal in rear side (external speaker output)
4. Connect Antenna to ANT terminal in rear side
5. Power on pressing power switch in front side (Front LCD screen shows initial status)
6. Locate stand-unit to conference place (embed folding-Mike and battery-pack)
7. Power on each Stand unit pressing front-TALK-button by 2~3 seconds
8. Check synchronization between Main controller and Stand unit (Antenna icon appears in the LCD of Stand unit)
9. Touch Stand unit-TALK-button, then the Mike goes to ON status
10. Considering conference management type, change Main controller and Stand unit setting
basic setup methodㅣ 10
2.4GHz Digital Wireless Conference System