User's Manual

9 / 21

Disable wireless LAN Interface : Close wireless function .

Band : you can select as below:

2.4G Hz(B)

:11b mode, rate is 11 Mbps

2.4G Hz (G)

:11g mode, rate is 54 Mbps

2.4G Hz(N)

:11n mode, rate is 150 Mbps(1T1R)300 Mbps(2T2R)

2.4G Hz (B+G)

:11b/g mode, rate is 11 Mbps and 54 Mbps

2.4G Hz(G+N)

:11g/n mode, rate is 54 Mbps,150 Mbps /300 Mbps

2.4G Hz(B+G+N)

:11b/g/n mode, rate is 11 Mbps,54 Mbps,150 Mbps

/300 Mbps

Mode: Can select one of AP

,CLIENT,WDS,AP+WDS

Network Type : default is infrastructure

, when Mode is Client , you also can

set it to Ad-hoc

SSID: Wireless LAN status authentication name ,User can access the wireless

networking through status authentication name only .

Channel Width: you can select 20MHz

and 40MHz.

Channel Sideband: you can select Upper

or Lower. default is Upper .

Channel Number : the current channel router used.

Broadcast SSID: you can select Disable

or Enable. default is Enable.

Associated clients &OLFN³Show Active Clients

´EXWWRQLWZLOOVKRZ³$FWLYH

:LUHOHVV&OLHQW7DEOH´<RXFDQVHHWKHFOLHQW¶VVWDWXV

Enable Mac Clone (Single Ethernet Client): Enable Mac Clone.

Enable Universal Repeater Mode (Acting as AP and client

simultaneously): Enable Universal Repeater Mode.

SSID of Extended Interface: Only when the Enable Universal Repeater Mode

is available.

3.3.3 Security Settings

This page allows you setup the wireless security. Turn on WEP or WPA by

using Encryption Keys could prevent any unauthorized access to your wireless

network.