Installation Guide

6 7

ASSEMBLY INSTRUCTIONS ASSEMBLY INSTRUCTIONS

1. Determine mounting method.

Downrod Mount (standard or angled ceiling)

IMPORTANT: lf angle mounting, check to make sure

the ceiling angle is not steeper than 20°.

4a. STANDARD DOWNROD INSTALLATION:

Insert downrod (E) through canopy (B), canopy

cover (C), and yoke cover (D). Thread wires

from fan motor assembly through downrod (E).

2. Install mounting bracket (A) to outlet box (not included)

by sliding mounting bracket (A) over the two outlet box

screws (not included). Securely tighten two outlet box

screws.

3. Remove preassembled pin and clip from downrod (E).

Save for later use.

Clip

5. Loosen preassembled set screws from yoke on

fan motor assembly (H). Slip downrod (E) into

housing yoke, aligning holes on both parts. Insert

previously removed pin through holes on yoke

and downrod (E), then insert previously removed

clip into pin until it snaps into place. Tighten set

screws.

Outlet box

IMPORTANT: If angle mounting, make sure open end

of mounting bracket (A) is installed facing the higher

part of the ceiling.

Clip

Set screw

Yoke

4b. EXTENDED DOWNROD INSTALLATION:

If you are installing the fan with a longer downrod (sold

separately), insert it through the canopy (B), canopy

cover (C) and yoke cover (D). Then, thread lead wire

(N) through the downrod and connect the MALE plug

from the top of motor assembly (H) to the FEMALE

plug from the lead wire (N).

Female Plug

Male Plug

NOTE: The male plug of the lead wire (N) should extend

out of the other end of the downrod.

NOTE: The remainder of the instructions will reference

downrod assembly (E), but note all of the instructions

are applicable even if an accessory downrod was used.

Page 6 Page 7