Installation Guide

8 9
ASSEMBLY INSTRUCTIONS
Hardware Used
7. Insert the receiver from the remote pack (M) into the
mounting bracket (A) with the at side towards the
ceiling. Connect BLACK wire from receiver to BLACK
wire from ceiling. Connect WHITE wire from receiver
to WHITE wire from ceiling. Connect all GROUNDED
(GREEN) wires together from fan to GREEN/
GROUNDED wire from ceiling. Connect the male plug
from fan to female plug from the receiver together.
8. Twist wire ends together and screw wire connectors
(AA) on in a clockwise direction. Tape wire
connectors (AA) and wires together with electrical
tape (not included).
7
8
x 4
Wire Connector
AA
11. Attach blade (G) under blade arm (F) using three
decorative screws (CC) and three blade screws
(DD). Repeat for remaining blades (G), blade arms
(F), decorative screws (CC) and blade screws (DD).
10. Slide canopy cover (C) over two screws and rotate
clockwise until it locks.
AA
9. Slide canopy (B) up against ceiling and over two
screws on mounting bracket (A). Rotate canopy (B)
clockwise to lock it into place. Tighten two screws.
NOTE: BLACK wire is hot power for fan and light kit.
WHITE wire is common for fan and light kit. GREEN
wire is grounded wire. lf house wires are different colors
than referred to above, stop immediately and consult a
professional electrician to determine proper wiring.
NOTE: After making connections, make sure bare
wire or wire strands are NOT visible. Place green
and white connections on opposite side of box from
black and blue connections. Splices should be turned
upward and pushed carefully up into outlet box.
Grounded/Green
Black
White
Grounded/
Green
Black
White
Blue
A
ASSEMBLY INSTRUCTIONS
Screws
B
A
9
NOTE: Adjust screws as necessary until canopy (B)
and canopy cover (C) are snug.
Hardware Used
C
10
DD
F
G
CC
11
6. Install hanger ball on top of downrod (E) into
mounting bracket (A) opening. Rotate fan until slot on
hanger ball engages the tab on mounting bracket (A).
IMPORTANT: Do NOT use this fan with a dimmer switch
or variable speed wall control. Using a dimmer switch or
variable speed wall control will damage the fan.
DANGER: Be careful when aligning tab to slot.
If not fully engaged, the fan could fall, which could
result in serious injury or death.
ON
ON / OFF
switch
NO Variable speed
wall control
NO Dimmer
switch
A
E
Tab
Slot
6
DD
Blade Screw x 15 + 1 extra
CC
Decorative Screw x 15
Page 8 Page 9