Installation Guide

1. Install Battery/Learning Process:
Remove the battery cover from the back of the remote found in
the remote pack (M). Insert the battery from the remote pack (M)
into the remote; ensure polarity of battery matches the polarity
indicated in the battery compartment: positive (+) to positive (+)
and negative (-) to negative (-). Replace battery cover.
If you need to change the dip switches in the remote control due
to a potential interference issue, slide the dip switches to your
choice of either up or down -- the factory setting is up. Within
30 seconds of turning the fan’s power on, press and hold the
“Learn” button in the remote controls battery compartment for 1
second. Once the receiver has detected the set frequency, the
downlight of the fan, if applicable, will blink twice. Replace the
battery cover. To conrm the remote control and receiver have
paired succesfully, press any of the fan speed control buttons on
the remote control.
2. Fan Speed Control/Dimmer:
Low speed
Medium speed
High speed
Fan off
Light on/off
NOTE: For the dimmer function, press and hold the light button.
Light will dim. Release the light button when light is at desired
level.
NOTE: This remote control has a memory function. The receiver
stores the fan speed and light setting when the fan is turned off.
When the fan is turned on again, it will start with the most recent
settings.
3. Reverse Switch:
When the season changes, you may want to change the
direction your fan spins. To switch between clockwise and
counterclockwise rotations, ip the fan reversal switch located
on the top of housing of the motor.
WARNING: Wait for fan to stop before reversing the switch.
A. In cooler weather, clockwise rotation creates an upward
airow, which moves hot air from the ceiling into the room.
Push the switch RIGHT and see a Snowake icon for
clockwise rotation.
B. In warm weather, counterclockwise rotation creates a
downward airow, which cools the air. Push the switch LEFT
and see a Sun icon for counterclockwise rotation.
12 13
ASSEMBLY INSTRUCTIONS
19. Install bulbs (L) into sockets.
20.
Place glass (K) into tter plate (I), aligning three
at areas on top ange of glass (K) with three
raised dimples in the tter plate (I). Turn glass (K)
clockwise until it stops.
20
18. Align two key slots on light tter assembly
(J) with two screws on tter plate (I). Place
light tter assembly (J) over two screws and
turn clockwise until it locks. Install previously
removed screw (Step 16, page 11) and
securely tighten all screws.
H
B
EE
18
OPERATING INSTRUCTIONS
Screw
Screw
I
J
L
19
Raised Dimples
Flat Area
K
I
REMOTE CONTROL:
NOTE: If you have more than one remote-controlled fan installed in the same location, you may want to
change the frequency of the remote control to avoid any possible interference between remote controls.
To change the frequency of the remote control, change the dip switch settings as described below:
2
1
3
Learn key
Dip switch
M
Sun icon Snowflake icon
Page 12