ITEM #0036261 CALERA CEILING FAN MODEL #00879 UL MODEL #CLRO52-II Harbor Breeze ® is a registered trademark of LF, LLC. All Rights Reserved. Español p. 15 ATTACH YOUR RECEIPT HERE Serial Number Purchase Date Questions, problems, missing parts? Before returning to your retailer, call our customer service department at 1-800-643-0067, 8 a.m. - 6 p.m., EST, Monday - Thursday, 8 a.m. 5 p.m., EST, Friday. XXXXX Lowes.
TABLE OF CONTENTS SAFETY INFORMATION Safety Information ................................................................................................................3 Package Contents ................................................................................................................4 Hardware Contents ..............................................................................................................5 Preparation ...................................................................
PACKAGE CONTENTS HARDWARE CONTENTS (shown actual size) A F AA CC BB G B Wire Connector Qty. 4 Fan Pull Chain Extension Qty. 1 (NOT TO SCALE) H C DD Rubber Gasket Qty. 1 (NOT TO SCALE) EE D Blade Screw Qty. 16 (NOT TO SCALE) E Blade Bracket Screw Qty.
INITIAL INSTALLATION INITIAL INSTALLATION 1. Determine mounting method. A-Downrod Mount (normal or angled ceiling) B-Closemount (normal ceiling only) 4. Install the mounting bracket (A) to the outlet box (not included) using the two screws provided with the outlet box. Tighten securely. 1 4 Outlet box Note: If using the angle mount, make sure the open end of mounting bracket (A) is installed facing the ceiling.
DOWNROD STYLE FAN MOUNTING 3. Loosen the two set screws from the yoke. Slip downrod (E) into yoke, aligning holes in downrod (E) and yoke. Insert the pin through yoke and downrod (E). Insert clip into pin until it snaps into place. Tighten set screws. Slide the yoke cover (D) down over the motor housing assembly (H). 4. lnstall hanger ball on the top of downrod (E) into mounting bracket (A) opening. Rotate fan until slot on hanger ball engages the tab on the mounting bracket (A).
WIRING FINAL INSTALLATION Note: BLACK wire is hot power for fan. BLUE wire is hot power for light kit in case of future light kit installation. WHITE wire is common for fan and light kit. GREEN wire is grounded wire. If house wires are different colors than referred to above, stop immediately. Consult a licensed electrician to determine proper wiring. 2. To connect wires, twist wire ends together and screw wire connectors (AA) on in a clockwise direction.
FINAL INSTALLATION OPERATING INSTRUCTIONS 5. Attach blade bracket (F) to the underside of motor housing assembly (H) using 2 blade bracket screws (EE). Tighten securely. PULL CHAIN: The fan pull chain is for motor speed control: High, Medium, Low and Off. Pull the chain once for each position. 5 REVERSE SWITCH: When the season changes, you may want to change to the direction your fan spins. To switch between clockwise and counterclockwise rotation, flip the fan reverse switch.
WARRANTY The manufacturer warrants this fan motor to be free from defects in workmanship and material present at time of shipment from the factory for a period of thirty years after the date of purchase by the original purchaser. The manufacturer also warrants that all other fan parts, excluding any glass to be free from defects in workmanship and material at the time of shipment from the factory for a period of three years after the date of purchase by the original purchaser.