Installation Guide

6 7
INITIAL INSTALLATION INITIAL INSTALLATION
DOWNROD STYLE FAN MOUNTING
1
4
1
3
2
Lowes.com/harborbreeze Lowes.com/harborbreeze
A
B
B
A
Remove
and save
Loosen but
Rubber
insert
and screw
do not remove
E
Clip
Pin
E
B
C
D
2
Outlet box
A
1. Determine mounting method.
A-Downrod Mount (normal or angled ceiling)
B-Closemount (normal ceiling only)
IMPORTANT: If angle mounting, check to make
sure the ceiling angle is not steeper than 20˚.
2. Remove and discard the four rubber inserts and
four mounting screws preassembled on the
underside of the motor housing assembly (H).
3. Remove the mounting bracket (A) from the
canopy (B) by loosening the four screws on the
top of the canopy (B). Remove the two
non-slotted screws and save.
4. Install the mounting bracket (A) to the outlet box (not
included) using the two screws provided with the outlet
box. Tighten securely.
Note: If using the angle mount, make sure the open end
of mounting bracket (A) is installed facing the ceiling.
Follow mounting instructions for Downrod Style Fan
Mounting on page 7 or Closemount Style Fan Mounting
on page 8, depending on mounting method (A or B)
chosen in Step 1 on page 6
1. Remove pin and clip from downrod (E).
2. Insert downrod (E) through canopy (B), canopy cover
(C) and yoke cover (D). Thread wires from the motor
housing assembly (H) through downrod (E).