Installation Guide

9
DOWNROD STYLE FAN MOUNTING
CLOSEMOUNT STYLE FAN MOUNTING
CLOSEMOUNT STYLE FAN MOUNTING
3 2
3
4
Lowes.com/harborbreeze
Lowes.com/harborbreeze
Lowes.com/harborbreeze
Lowes.com/harborbreeze
Clip
Pin
Yoke
Set screw
E
D
H
H
H
B
Hardware Used
x 1
Rubber gasket
B
A
Hook
CC
CC
Tab
Slot
A
E
4
4
B
C
B
C
1
1
8
3. Loosen the two set screws from the yoke. Slip downrod
(E) into yoke, aligning holes in downrod (E) and yoke.
Insert the pin through yoke and downrod (E). Insert clip
into pin until it snaps into place. Tighten set screws.
Slide the yoke cover (D) down over the motor housing
assembly (H).
2. Remove every other screw from the top of the motor
housing assembly (H) -- for a total of 3 screws -- and
save.
3. Place the rubber gasket (CC) over the remaining screws
on motor housing assembly (H). Pull wires through hole
in canopy (B) and attach canopy (B) to motor housing
(H) using the three screws removed in previous step.
Tighten the screws securely.
4. Temporarily hang the canopy (B) onto the hook on the
mounting bracket (A) using one of the non-slotted holes
in the canopy (B). This will allow for hands-free wiring.
4. lnstall hanger ball on the top of downrod (E) into
mounting bracket (A) opening. Rotate fan until slot on
hanger ball engages the tab on the mounting bracket
(A).
DANGER: Be careful when aligning the tab to the slot!
If not fully engaged, there is a possibility of fan falling,
which may result in serious injury or death.
You may now proceed to the WIRING section on page 10.
1. Remove the canopy cover (C) from the bottom of the
canopy (B).