Installation Guide

1312
FINAL INSTALLATION
6. Remove the three screws from the switch
housing cover (I).
7. Attach the switch housing cover (I) to the switch
housing (H). Align holes in switch housing
cover (I) with holes on outer edge of the switch
housing (H). (Note: The wide gap in the edge
of the switch housing cover (I) should align
with reverse switch on the switch housing
(H).) Re-insert screws and secure all screws.
Add fan pull chain extension (BB). If using fan
WITHOUT the light kit, assembly is complete.
I
6
H
I
BB
7
FINAL INSTALLATION
8. Remove the plug from the center hole in the
switch housing cover (I).
9. Remove the hex nut from the light kit (J).
10. Insert the black and white wires from the
light kit (J) through the center hole in the
switch housing cover (I). Hold wires taut
while installing switch housing cover (I) to
prevent the wire from twisting. Tighten the
light kit (J) onto the switch housing cover (I).
Install the hex nut removed in Step 9.
plug
I
8
hex nut
J
9
hex nut
I
J
10
5. Fasten the blade bracket (E) to the motor by
inserting the alignment post into the slot on the
bottom of the motor housing (G) and tightening
the blade bracket screws with washers.
Please note that the blade bracket screws with
washers are pre-installed into the blade bracket
(E). Repeat the step for the remaining blade
brackets (E).
screw with
washer
alignment
post
slot
E
G
5
If you wish to use the fan WITHOUT the light
kit, continue to Step 7.
If you wish to use the fan WITH light kit, skip to
Step 8.
Hardware Used
Fan pull chain extension
x 1
BB