Installation Guide

INITIAL INSTALLATION

WARNING:Toreducetheriskofre,electricalshockorpersonalinjury,wireconnectors

provided with this fan are designed to accept only one 12-gauge house wire and two lead wires

from the fan. If your house wire is larger than 12-gauge and/or there is more than one house wire to

connect to the two fan lead wires, consult an electrician for the proper size wire connectors to use.

CAUTION: Be sure the outlet box is properly grounded or that a ground (green or bare) wire is present.

4. Using wire connectors (DD), connect wires from

receiver (C) -- preassembled to upper mounting bracket

(B) -- and house supply wires according to the diagram

and these steps:

• Connect the red wire from receiver (C) to the black

(hot) house supply wire.

• Connect the white wire with red label from the receiver

Note: The remaining wires will be connected later in the

installation process (page 10).

Hardware Used

Wire Connector x 2

5. Wrap electrical tape (not included) around each

individual wire connector (DD) down to the wire.

6. Turn the spliced/taped wires upward and gently push

the wires and wire connectors (DD) into the outlet box.

WARNING: Ensure no bare wire or wire strands are

visible after making connections.