Installation Guide

OPERATING INSTRUCTIONS
1. To operate the fan using the remote, press and release the following buttons:
High - Turns fan on high speed.
Medium - Turns fan on medium speed.
Low - Turns fan on low speed.
Fan Off - Turns fan off.
Walk Away Light Delay
TM
- Tap once will turn fan light off after 1 minute. Note: Light blinks to conrm that Walk Away
Light Delay is active. Press any other button to cancel.
Light Control
Incandescent Bulbs - Press light control to turn lights off and on. Press and hold light control to dim or brighten the lights.
CFL -Turns the lights on and off. Note: The dimmer function does not work with CFL.
Home Shield
TM
- Press and hold Light and Delay buttons for 3 seconds. Lights cycle on for 5-20 minutes and off for 60
minutes, simulating occupancy. Cycle repeats continuously until any other button is pushed to discontinue Home Shield
mode.
D/O - Switch should be set to “O” for CFLs, which disables the dimming function. Flip to “D” for incandescent and other
dimmable bulbs.
Learn - Syncs remote control to receiver. The remote was synced at the factory. Should it become necessary to
re-sync the remote, turn off the main power, then turn it back on. Within 30 seconds, use a small screwdriver to press
and hold the learn button on the remote for 3 seconds. The fan will turn on and light (if applicable) will blink three times,
signaling a successful synchronization.
9125 • 041716
Printed in China
High
Medium
Low
Off
Delay
Light Control
Learn
Learn
D/O
D/O
Home Shield
1
F
A