ITEM #1133114 SAIL STREAM CEILING FAN MODEL #41695 Español p. 18 Harbor Breeze® is a registered trademark of LF, LLC. All Rights Reserved. ATTACH YOUR RECEIPT HERE Purchase Date _________________________ Questions, problems, missing parts? Before returning to your retailer, call our customer service department at 1-800-643-0067, 8 a.m. - 6 p.m., EST, Monday - Thursday, 8 a.m. - 5 p.m., EST, Friday.
TABLE OF CONTENTS Package Contents. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Hardware Contents. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Safety Information. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Preparation . . . . . . . . . . . . . . . . .
PACKAGE CONTENTS E M A B F C G J H I D K L N PART A B C D E F DESCRIPTION Mounting Bracket Canopy (preassembled to Motor Assembly [C]) Motor Assembly Fitter Plate (preassembled to Motor Assembly [C]) Switch Housing Light Pan QUANTITY 1 1 1 1 1 1 G Locking Ring (preassembled to Bowl Housing [H]) 1 H I J K L M N Bowl Housing Glass Bowl (preassembled to Bowl Housing [H]) Blade Light Pan Screw (preassembled to Fitter Plate [D]) Remote Pack Mounting Bracket Screw (preassembled to Mounting Bracket
HARDWARE CONTENTS (shown actual size) AA BB Wire Connector Qty. 3 + 1 extra Blade Screw Qty. 9 + 1 extra CC Blade Washer Qty.
SAFETY INFORMATION Please read and understand this entire manual before attempting to assemble, operate or install the product. • Before you begin installing the fan, disconnect the power by removing fuses or turning off the circuit breakers. • Make sure all electrical connections comply with local codes, ordinances, the National Electrical Code and ANSI/NFPA 70-199. Hire a qualified electrician or consult a do-it-yourself wiring handbook if you are unfamiliar with installing electrical wiring.
SAFETY INFORMATION CAUTION: Read all instructions and safety information before installing your new fan. Review the accompanying assembly diagrams. CAUTION: Be sure the outlet box is properly grounded or that a ground (green or bare) wire is present. CAUTION: Carefully check all screws, bolts and nuts on the fan motor assembly to ensure they are secured. CAUTION: This device complies with part 15 of FCC Rules.
INITIAL INSTALLATION 1. Turn off the circuit breakers and the wall switch to the fan supply line leads. 1 DANGER: Failure to disconnect the power supply prior to installation may result in serious injury or death. 2. This fan is intended for Flushmount Installation. Standard Mounting, Angle Mounting, and Closemount installations are not available. 3. Ensure the blades (J) will be at least 30 in. from any obstructions and will be at least 7 ft. above the floor.
INITIAL INSTALLATION 4. Loosen the four light pan screws (K) preassembled to the fitter plate (D). Then, turn the orange shipping block counterclockwise and remove. Discard the shipping block. 4 D K Shipping Block 5. Feed the supply wires from the outlet box through the center hole in the mounting bracket (A). Then, secure the mounting bracket (A) to the outlet box (not included) using screws and washers provided with the outlet box.
WIRING WARNING: To reduce the risk of fire, electrical shock or personal injury, wire connectors provided with this fan are designed to accept only one 12-gauge house wire and two lead wires from the fan. If your house wire is larger than 12-gauge and/or there is more than one house wire to connect to the two fan lead wires, consult an electrician for the proper size wire connectors to use. CAUTION: Be sure the outlet box is properly grounded or that a ground (green or bare) wire is present. 1.
FINAL INSTALLATION 1. Loosen all four mounting bracket screws (M), then completely remove two mounting bracket screws (M) from opposite sides of the mounting bracket (A). 1 M Slide the canopy (B) over the mounting bracket (A), aligning the slotted holes in the canopy (B) with the pre-loosened mounting bracket screws (M) in the mounting bracket (A). Twist the canopy (B) clockwise to lock. Then re-insert the mounting bracket screws (M) and securely tighten all screws. 2.
FINAL INSTALLATION 4. Remove one of the switch housing screws (N) from the light pan (F), and loosen (do not remove) the other two screws. 4 Connect the single-pin connector from the center of the fitter plate (D) to the single-pin connector from the switch housing (E) -- blue to black and white to white. F N D Single-pin Connector 5.
FINAL INSTALLATION 7. Remove the battery cover from the back of the remote found in remote pack (L). Insert the battery from remote pack (L) into the remote; ensure polarity of battery matches the polarity indicated in the battery compartment -- positive (+) to positive (+) and negative (-) to negative (-). Replace the battery cover and press the high fan speed button on the remote to ensure the remote turns on the fan.
OPERATING INSTRUCTIONS 1. To operate the fan using the remote from remote pack (L), press and release the following buttons: III - High speed II - Medium speed I - Low speed Fan Off - Turns power to fan off. Light Delay - Tap the light delay button, which will turn off the light after one minute. Tap the light control button to exit light delay mode. Light Control - Tap the light control button to turn the light off and on. Press and hold light control button to dim or brighten the lights.
CARE AND MAINTENANCE At least twice each year, tighten all screws on the fan. Clean the motor housing with only a soft brush or lint-free cloth to avoid scratching the finish. Clean the blades with a lint-free cloth. Battery Replacement: Use A23 12-volt battery. Exhausted batteries should be removed from the remote. Important Shut off the main power supply before you begin any maintenance tasks. Do not use water or a damp cloth to clean the ceiling fan. TROUBLESHOOTING PROBLEM The fan does not move.
TROUBLESHOOTING PROBLEM POSSIBLE CAUSE 1. The blades are loose. CORRECTIVE ACTION 1. Check and tighten all screws that hold the fan blades to the blade arms and the motor. 2. There is a cracked blade. 2. Replace the cracked blade. The fan is noisy. 3. The outlet box is not secure. Remote control does not work. 3. Ensure the ceiling outlet box is secured to the building structure. 4. The mounting bracket is not secure. 4.
LIFETIME LIMITED WARRANTY The manufacturer warrants this fan to be free from defects in workmanship and materials present at time of shipment from the factory for a lifetime from the date of purchase by the original purchaser. The retailer also warrants that all other fan parts, excluding any glass or plastic blades, to be free from defects in workmanship and material at the time of shipment from the factory for a period of one year after the date of purchase by the original purchaser.
REPLACEMENT PARTS LIST For replacement parts, call the customer service department at 1-800-643-0067, 8 a.m. - 6 p.m., EST, Monday - Thursday, 8 a.m. - 5 p.m., EST, Friday.
