Installation Guide

13
OPERATING INSTRUCTIONS
1. To operate the fan using the remote from remote pack
(L), press and release the following buttons:
III - High speed
II - Medium speed
I - Low speed
Fan O - Turns power to fan o.
Light Delay - Tap the light delay button, which will
turn o the light after one minute. Tap the light control
button to exit light delay mode.
Light Control - Tap the light control button to turn the
light o and on. Press and hold light control button to
dim or brighten the lights.
Seasonal Slide Switch - In warmer weather, push the
seasonal slide switch left toward sun icon, which will
result in downward airow creating a wind chill eect.
In cooler weather, push the seasonal slide switch right
toward the snowake icon, which will result in upward
airow that can help move hot air o the ceiling.
Important: Wait for the fan to stop before moving the
seasonal slide switch. The seasonal slide switch must
be set either completely left or right in order for the fan
to function correctly. If the switch is set in the middle
position, the fan will not operate.
Low Battery Indicator - LED Indicator will ash for
one minute as a reminder to replace the 12-volt battery.
2. Remove battery door from back of the remote from
remote pack (L) to access the following:
D/CFL Switch - set to “D” at the factory. The switch
should remain in the “D” position.
LEARN - Syncs remote to receiver (see
troubleshooting for instructions).
1
High Speed
Led Indicator
Medium Speed
Low Speed
Fan O
Light Delay
Light Control
Seasonal Slide
Switch
Battery Compartment
(battery door removed)
LEARN
2
CFL
D