Installation Guide

ASSEMBLY INSTRUCTIONS
7
6.
5a.
Remove wire connectors from WHITE and
BLUE (or BLACK) wires labeled FOR LIGHT in
switch housing. Connect WHITE wire from light
kit fitter (A) to WHITE wire from fan. Connect
BLACK wire from light kit fitter (A) to BLUE (or
BLACK) wire from fan. Use wire connectors that
were previously removed to make the
connections.
WARNING: To reduce the risk of fire,
electrical shock, or personal injury, each wire
connector used with this light kit should accept
only one 18-gauge wire from the light kit and
one 18-gauge wire from the ceiling fan. If there
are three or more wires to connect or any of the
wires is larger than 18-gauge, consult an
electrician for the proper size wire connectors to
use.
NOTE: Screw wire connectors on in a clockwise
direction.
If applicable, re-connect male plug from motor
housing to female plug from switch housing. Be
sure that plugs connect securely.
5b.
BLUE
Female Plug
Male Plug
BLACK
WHITE WHITE
Wire
Connectors
BLUE (or BLACK)
BLACK
WHITE
WHITE
Switch
Housing
Cap
Wire
Connectors
Switch
Housing
Motor Housing
Motor
Housing
A
A
5a
5b
6
6
Wrap electrical tape (not included) around
each individual wire connector down to the
wire.
WARNING: Make sure no bare wire or
wire strands are visible after making
connections.