Installation Guide

ASSEMBLY INSTRUCTIONS
8.
9.
8
9
8
7a.
A
E
7b
6
6
7a
Align three holes in switch housing with three
holes in switch housing plate. [To re-attach
switch housing cap, proceed to Step 7b.]
Re-attach switch housing with three screws
previously removed (Step 2a, page 5).
Tighten all screws securely.
Align holes in switch housing cap with holes
at bottom of switch housing. Re-attach
switch housing cap with three screws
previously removed (Step 2b, page 5).
Tighten all screws securely.
Switch
Housing
Cap
Switch
Housing
7b.
Install bulbs (E).
WARNING: When replacing bulbs,
please allow bulbs and shade to cool
down before touching.
A
A
D
Switch
Housing
Plate
Switch
Housing
Remove pull chain extension from fan pull
chain if you have not already done so. Thread
preassembled fan and light pull chains through
corresponding pull chain guides on the outer
rim of the light kit fitter (A).
Align slots on shade (D) with protrusions on the
inside of the light kit fitter (A). Turn shade (D)
clockwise until it no longer turns.
NOTE: Pull down gently on the shade (D) to
make sure it is secured completely.
Pull
Chain
Guide
Pull
Chain
Guide