Specifications Weight Capacity Overall Dim. Page 2 100 lb. 21-1/2″ x 15-5/8″ x 28-3/4″ For technical questions, please call 1-800-444-3353.
Important Safety Information Assembly Precautions 1. Assemble only according to these instructions. Improper assembly can create hazards. 2. Wear ANSI-approved safety goggles and heavy-duty work gloves during assembly. 3. Keep assembly area clean and well lit. 4. Keep bystanders out of the area during assembly. 5. Do not assemble when tired or when under the influence of drugs or medication. 6.
Assembly Instructions Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this document including all text under subheadings therein before set up or use of this product. Note: When attaching hardware, hand tighten only until the unit is together, then use the appropriate tools to tighten the hardware. 1. Put a Wheel (2) on the end of the Axle (9) and secure it with Washer and Cotter Pin (11). See Figure A. Repeat on the other side. 2.
3. Connect the bottom (note the hole 4. locations in the diagram) of the Left Support (7a) to the Bottom Shelf (1) using Bolts, Washers, and Nuts (10). 5. See Figure C. Repeat on other side with Right Support (7b). Attach the Middle Shelf (5) to the Left and Right Supports (7a,7b) using Bolts, Washers, and Nuts (10). Place a Hook (8) over the holes on the outside of the top of a Support (7a/7b), and place the Bolts (10) through both the Hook (8), Support (7a/7b), and the Top Shelf (6).
Operation 1. Make sure that the welder and all accessories combined do not exceed the weight capacity of this cart. 3. Place the welder on the top shelf and the other accessories on the other shelves. 2. Place any gas cylinders on the back shelf, and secure in place with both chains. Adjust chains’ length to hold the cylinder(s) securely. 4. Make sure everything is secure and the cart is well balanced.
Parts List and Diagram Part 1 2 3 4 5 6 7a Description Bottom Shelf Asm. Wheel Swivel Caster Back Panel Middle Shelf Top Shelf Left Support Qty 1 2 2 1 1 1 1 Part 7b 8 9 10 11 12 13 Description Right Support (not shown) Hook Axle Bolt, Washer, Nut (set) M6x12 Flat Washer, Cotter Pin (set) Cap Chain Qty 1 2 1 33 2 2 2 a Record Serial Number Here: Note: If product has no serial number, record month and year of purchase instead.
PLEASE READ THE FOLLOWING CAREFULLY THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY DIAGRAM IN THIS DOCUMENT AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT, OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT.