SAVE THIS MANUAL Keep this manual for the safety warnings and precautions, assembly, operating, inspection, maintenance and cleaning procedures. Write the product’s serial number in the back of the manual near the assembly diagram (or month and year of purchase if product has no number). Keep this manual and the receipt in a safe and dry place for future reference.
. Thoroughly test vehicle lights and tow lights before use. 4. Mount lights in proper orientation. Amber lights must face forward and red lights must face backward. Improper orientation can confuse or distract drivers, causing a traffic hazard. 5. Install on a 12 V negative ground circuit only. Installing on different circuit can result in electric shock, fire, or property damage. 6. Turn off vehicle and set the parking brake before installation or testing. 7.
UNPACKING SPECIFICATIONS When unpacking, check to make sure that the item is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible. Electrical Requirements 12 VDC 4.3 A Bulb Type 12 VDC 21/5 W (#1157 Type) Connector 4-way Flat WIRING Note: Some towing vehicles may already have a 4-way Flat Connector, “Trunk” plug wired in. For those vehicles, skip the following wiring instructions.
3. Verify that all wires are held securely. 4. Plug the “Trunk” Connector (23) into the “Trailer” Connector (18). 5. WARNING! If the Wire Splices (21) are used improperly and damage the vehicle’s wiring, the vehicles rear lights may fail, resulting in a traffic hazard. Have an assistant operate the vehicle’s lights while you carefully check that the vehicle lights and the towing lights all work properly after installation.
8. After towing, disconnect “Trailer” Connector, remove tow lights from towed vehicle, clean with a moist cloth, and store in dry location out of reach of children. Do not drag the magnetic bases to disconnect, as they may scratch the body paint. Push to tilt then remove. BULB REPLACEMENT CAUTION Wear ANSI-approved safety goggles and heavyduty work gloves when replacing the bulb. 1. Make sure the burned-out bulb has cooled completely. 2.
ASSEMBLY DIAGRAM Part Numbers 21, 22, 23 - see photos on page 4. SKU 69626 For technical questions, please call 1-888-866-5797.
Limited 90 Day Warranty Harbor Freight Tools Co. makes every effort to assure that its products meet high quality and durability standards, and warrants to the original purchaser that this product is free from defects in materials and workmanship for the period of 90 days from the date of purchase.