Product manual

Page 7
For technical questions, please call 1-800-444-3353.
SKU 37999
Bottom Crossbeam (21)
Top
Crossbeam
(22)
Press
Rod
Guides
(23)
Bolts (13)
Nuts
(14)
Figure 3
3. To Assemble the Crossbeams
(21/22):
Attach a Press Rod Guide (23) to
the center of the Top and Bottom
Crossbeams (21 & 22) by securing
in place with the Bolts (13) and Nuts
(14).
Header Supports (25)
Uprights (18)
Bottom Crossbeam (21)
Top
Crossbeam
(22)
Nut
(9)
Nut
(26)
Bolt
(11)
Bolt
(10)
Figure 4
4. To Attach the Crossbeams (21/22)
and Header Supports (25) to the
Uprights (18):
Position one end of the Bottom a.
Crossbeam (21) with the second
hole at the top of the Upright and
secure with a Bolt (11) and Nut (9).
Repeat for the other end.
Position one end of the top b.
Crossbeam (22) at the top end of
the Upright (18). Position Header
Supports (25) at its sides, thread a
Bolt (10) through the Crossbeam,
Header Support, Top Crossbeam,
the other Header Support and out
through the other Upright. Attach Nut
(26). Repeat for the other end.
Header (2)
Header Supports (25)
Nut (26)
Nut (14)
Bolt (5)
Bolt (6)
Figure 5
5. To Attach the Header Supports (25)
to the Header (2):
Attach the four Header Supports (25)
to the sides of the Header (2) using
two Bolts (6) and Nuts (26). Insert
two Bolts (5) through the lower holes
at the top of the Header Supports and
secure with Nuts (14).
Figure 6
Support Pins (19)
Upright (18)
Press Apron (12)
6. To install the Press Apron (12):
Slide the Support Pins (19) into the a.
holes in the Uprights (18).
Angle the Press Apron (12) so the b.
rails of the Press Apron straddle the
Uprights, then lower into place so