Product manual

Page 8
For technical questions, please call 1-800-444-3353.
SKU 37999
the Press Apron rests on the Support
Pins.
Eye Bolts (7)
Nut (8)
Press Rod (24)
Figure 7
7. Insert the Eye Bolts (7) into the holes
in the Press Rod (24) and secure in
place with the Nuts (8).
Figure 8
Bottle
Jack
(1)
Springs (4)
Header (2)
Eye Bolts (7)
Bolt (5)
Header
Supports (25)
Press
Rod
Guides
(23)
Press
Rod
(24)
8. To install the Bottle Jack assembly:
Slide the Press Rod (24) through the a.
Press Rod Guides (23).
Hang the Springs (4) from the Bolts b.
(5) in the Header Supports (25).
Bleed the Bottle Jack (see Bleeding c.
the Bottle Jack, page 9) and make
sure it is fully collapsed. Center the
Bottle Jack (1) on the Press Rod
(24).
Slide the Press Rod up so the Bottle d.
Jack ts into the guide ring on the
Header (2).
Hook the Springs (4) into the Eye e.
Bolts (7).
Adjust the Eye Bolts so the f.
assembly is tight and secure.
Tighten the Bolts and Nuts which 9.
secure the Press Rod Guides (23),
making sure that the press Rod is
centered in them.
Place the Arbor Plates (20) on the 10.
Press Apron (12).
Bleeding the Bottle Jack
Plunger/
Fulcrum
Handle (3)
Elevating
Screw
(some models)
Oil Fill Hole
Oil Filler
Plug
Valve
Release
Screw
Saddle
Figure 8
IMPORTANT! Before rst use,
check for proper hydraulic oil level
in the Jack. Then thoroughly test the
Jack for proper operation prior to its
actual use. If the Jack does not work
properly, bleed excess air from its
hydraulic system as follows:
Open the Release Valve.1.