Product manual
Page 9
For technical questions, please call 1-800-444-3353.
SKU 37999
Remove the Oil Filler Plug and ll the 2.
Jack with hydraulic uid to the full
level.
Apply pressure to the Saddle, and 3.
pump the Handle (3) quickly several
times.
Check the Oil Fill Hole and, if 4.
necessary, top off the Oil Fill Hole
with hydraulic oil.
Replace the Oil Filler Plug and close 5.
the Release Valve.
Test the Jack several times for proper 6.
operation before putting into use.
If, after bleeding, the Jack still does
not appear to be working properly,
do not use the Jack until it has
been repaired by a qualied service
technician.
General Operating Instructions
The Shop Press can be used for
a variety of functions including
electric motor and armature
repair, installation and removal of
pressure tted parts such as gears
and bearings, and bending or
straightening of metal. Care should
be taken in set up and operation of
the Shop Press to avoid damage or
injury.
To operate the Shop Press:
Use the Support Pins (19) to adjust 1.
the height of the Press Apron (12).
Note: The Press Apron (12) should be in
the highest position possible with the
workpiece as close as possible to the
ram of the Press Rod (24).
Place the item to press between the 2.
Arbor Plates (20).
WARNING: Make sure there is no
obstruction (such as a stray bolt or
debris) under the Arbor Plates. Such
items create an uneven surface
which can cause the Arbor Plates to
break under pressure.
WARNING: When pressing two items
together, the items must be lined
up vertically. If not, one item may
forcefully eject itself sideways from
the unit.
Using the Jack Handle (3), jack down 3.
the Jack Plate until the ram of the
Jack Plate contacts your workpiece.
Make sure if you are pressing
two items together, that they are
in vertical alignment. Continue to
operate the Handle to press the work
piece.