WARNING SYMBOLS AND DEFINITIONS This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety messages that follow this symbol to avoid possible injury or death. Indicates a hazardous situation which, if not avoided, will result in death or serious injury. Indicates a hazardous situation which, if not avoided, could result in death or serious injury. Indicates a hazardous situation which, if not avoided, could result in minor or moderate injury.
2. Never hold piece being cut in your hands or across your leg. Secure the workpiece to a stable platform. It is important to support the work properly to minimize body exposure, Disc binding, or loss of control. 8. This product is not a toy. Do not allow children to play with or near this item. 3. Do not reach underneath the workpiece or remove wood shavings from the cutting area while the Disc is rotating. The safety guard cannot protect you from the Carving Disc below the workpiece. 11.
Kickback and Related Warnings (continued) 4. Use special care when working corners, sharp edges etc. Avoid bouncing and snagging the accessory. Corners, sharp edges or bouncing have a tendency to snag the rotating accessory and cause loss of control or kickback. 5. This tool is designed to reduce the risk of kickback. However, improper assembly, installation, or usage may still cause kickback.
Adjusting the Safety Guard 1. Lay the grinder to be used on its side and loosen the hardware securing the safety guard in place. 3. Tighten the hardware holding the guard in place and ensure it is secure. Adjust if necessary before proceeding. 2. Rotate the safety guard until it is at an approximate 45° angle with the grinder body. Refer to Figure B.
Operation Instructions Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this document including all text under subheadings therein before set up or use of this product. Workpiece and Work Area Set Up 1. Designate a work area that is clean and well-lit. The work area must not allow access by children or pets to prevent distraction and injury. 2.
Maintenance TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION: Make sure that the Power Switch/Trigger of the power tool is in the off-position and unplug the tool from its electrical outlet before performing any procedure in this section. For optimum performance, periodically sharpen the saw chain: a. Wear heavy-duty work gloves and remove the Carving Disc from the power tool. b. Replace the center plug supplied with the accessory to hold the Carving Disc assembly together. c.
3491 Mission Oaks Blvd.