Product manual

Page 2 For technical questions, please call 1-888-866-5797. Item 61638
WARNING SYMBOLS AND DEFINITIONS
This is the safety alert symbol. It is used to alert you to
potential personal injury hazards. Obey all safety messages
that follow this symbol to avoid possible injury or death.
Indicates a hazardous situation which, if not avoided,
will result in death or serious injury.
Indicates a hazardous situation which, if not avoided,
could result in death or serious injury.
Indicates a hazardous situation which, if not avoided,
could result in minor or moderate injury.
Addresses practices not related to personal injury.
Important Safety Information
To prevent serious injury, amputation, and DEATH, read and follow all
power tool instructions and all instructions included with this item.
Save all warnings and instructions for future reference.
Set up Precautions
1. The grinder’s safety guard MUST be
positioned as described in Adjusting
the Safety Guard on page 5 prior
to installing and using Carving Disc.
2. DO NOT install Carving Disc on any
grinder that requires mechanically
modifying the safety guard to
achieve proper positioning.
3. Set up only according to these instructions.
Improper assembly can create hazards.
4. Install only on 4" or 4-1/2" angle grinder
equipped with a constant pressure
switch (paddle, dead man or kill switch),
with a 5/8" spindle and a maximum
speed of 14,000 RPM or less.
5. Wear ANSI-approved safety goggles and
heavy-duty work gloves during set up.
6. Do not carve wood containing foreign
objects. Remove all screws, nails,
staples and other obstructions from
workpiece before using Carving Disc.
7. Make sure that the power switch/trigger
of the power tool is in the off-position and
unplug the tool from its electrical outlet
before performing any set up procedures.
8. Keep set up area clean and well lit.
9. Keep bystanders out of the
area during set up.
10. Do not set up when tired or when under the
influence of alcohol, drugs or medication.
Use Precautions
1. DANGER: Keep hands away from
cutting area and the Carving Disc.
Keep your second hand on auxiliary
handle, or motor housing.
If both hands are holding the grinder,
they cannot be cut by the Carving Disc.