Product manual

Page 5For technical questions, please call 1-888-866-5797.Item 61638
Adjusting the Safety Guard
1. Lay the grinder to be used on its side
and loosen the hardware securing
the safety guard in place.
2. Rotate the safety guard until it is at
an approximate 45° angle with the
grinder body. Refer to Figure B.
3. Tighten the hardware holding the guard
in place and ensure it is secure. Adjust
if necessary before proceeding.
Incorrect Safety
Guard Position
Correct Safety
Guard Position
Safety Guard
Figure B
Disc and Chain Assembly
The Carving Disc consists of three
components, a top disc stamped TOP,
a bottom disc stamped BOTTOM, and a
saw chain. To assemble the components
use the following procedure:
1. Place the bottom disc with the word
BOTTOM facing up on a flat surface.
2. Place the saw chain on the bottom
disc with rakers facing left as shown in
Figure C and arrange chain around the
outside edge of the disc, making sure
chain link tangs fit over disc perimeter.
Note: Chain direction is critical for proper
operation. If assembled in the wrong direction,
the saw chain blades will not cut effectively
and may burn the wood due to heat buildup.
3. Place the top disc with the word TOP
facing up onto the saw chain and bottom
disc. Make sure that the slots in the top
disc line up with the slots in the bottom
disc and make minor adjustments to the
position of the top and bottom discs until
the chain is secured between them.
Raker
Tang
Figure C