Product manual

Page 6 For technical questions, please call 1-888-866-5797. Item 61638
Operation Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section
at the beginning of this document including all text under subheadings therein
before set up or use of this product.
Workpiece and Work Area Set Up
1. Designate a work area that is clean
and well-lit. The work area must not
allow access by children or pets to
prevent distraction and injury.
2. Route the power cord along a safe
route to reach the work area without
creating a tripping hazard or exposing
the power cord to possible damage.
The power cord must reach the work
area with enough extra length to allow
free movement while working.
3. Secure loose workpieces using a
vise or clamps (not included) to
prevent movement while working.
4. There must not be hazardous objects, such
as utility lines or foreign objects, nearby
that will present a hazard while working.
5. You must use personal safety equipment
including, but not limited to, ANSI-
approved safety goggles underneath
full face shield, hearing protection,
and heavy-duty work gloves.
Operation
TO PREVENT SERIOUS INJURY: Grip the tool firmly in both hands.
1. Follow the manufacturer’s operating
instructions and safety warnings
applicable to your angle grinder.
2. Make sure that the switch/trigger is in
the off-position, then plug in the tool.
3. Turn on the switch or squeeze the
trigger to start the tool. DO NOT
start the tool with the Carving Disc
in contact with the workpiece.
4. Allow the Carving Disc to come up to full
speed before touching the work material.
5. Use both hands to operate grinder.
Hold tool at main housing, and use
auxiliary handle on top/side.
6. Apply the Carving Disc to the
work material, allowing the tool
to operate at full speed.
WARNING! Cut by pulling the saw back
towards you, not pushing away from you.
7. Do not use excessive pressure or force
the Carving Disc into the workpiece. If
the tool bogs down, use lighter pressure.
Allow the tool to do the work.
8. Periodically remove sawdust and wood
shavings from around and under the
grinder’s on/off switch to prevent buildup of
debris and ensure safe switch operation.
9. TO PREVENT ACCIDENTS, AFTER USE:
Turn off the tool.
WARNING! Allow the tool to come to a
complete stop before setting it down.
Unplug the tool. Remove the Carving
Disc from the grinder, replace
center plug to hold the Carving Disc
assembly together, then store the Disc
indoors out of children’s reach.