Product manual

SKU 93458 For technical questions, please call 1-800-444-3353 PAGE 7
Nosepieces:
1. The Riveter comes with four Nosepieces. The Nosepiece part numbers and sizes
are as follows: (1A = 3/16”), (1B = 5/32”), (1C = 1/8”), (1D = 3/32”).
2.
NOSEPIECE
(1A, 1B, 1C, 1D)
FRAME HEAD
(11)
SAFETY CAP
(23)
TRIGGER
(40)
FRAME
CAP NUT
(22)
QUICK CONNECTOR
(53)
FIGURE D
Use the Spanner (36) to remove the old nosepiece and install the new one. Tight-
en the new nosepiece in place before use. (See Figure D.)
OPERATING INSTRUCTIONS
1. Secure the Safety Cap (23) rmly to the Riveter by tightening the Frame Cap Nut
(22). While securing turn the slot in the Safety Cap upward to avoid spilling used
rivet pins. (See Figure D.)
2. Depending on the size of rivet’s pin used, attach the corresponding Nosepiece size
(3/16”, 5/32”, 1/8”, or 3/32”) with the Spanner (36).
(See Figure D.)
3. IMPORTANT: When drilling rivet holes in a workpiece, use the same diameter drill
bit as the outer diameter of rivet you will be using.
4. Attach an air hose to the Quick Connector (53) of the Riveter. (See Figure D.)
5. Turn on the air compressor, and set its regulator at 90 PSI. Do not exceed 90
PSI.
REV 07i