Product manual
SKU 93458 For technical questions, please call 1-800-444-3353 PAGE 8
INSPECTION, MAINTENANCE, AND CLEANING
WARNING! Wear ANSI-approved safety impact goggles when performing any
inspection, maintenance, or cleaning procedures.
WARNING! Prior to performing any inspection, maintenance, or cleaning of the Riv-
eter, make sure to disconnect the air hose from the tool. Then, squeeze the Trig-
ger (40) again to release any compressed air in the Riveter.
WARNING! All maintenance, service, and repairs not mentioned in this manual must
only be performed by a qualied service technician.
1. To clean the exterior of the Riveter, wipe with a clean, damp cloth using a mild
detergent or mild solvent. Do not immerse the tool in liquids.
2. To clean and change the Jaws:
a. Unscrew and remove the Frame Head (11), using the Spanner (36).
b. Use the Spanner (36) to unscrew and remove the Jaw Cases (6-1, 6-2). Use care
as there is a Spring (10) behind the Jaw Case (6-2) which may y out.
c. Remove the Jaws (7) from between the Jaw Cases (6-1, 6-2).
d. If you are going to clean the Jaws (7), use a steel brush and mild solvent. Then,
apply a light coat of machine oil to the Jaws. If you are going to replace the Jaws,
the entire assembly (6-1, 6-2, 7, 8, 9, & 10) must be replaced at the same time,
6. Insert the small end of a rivet fully through the Nosepiece (1A, 1B, 1C, or 1D).
CAUTION! Keep clear of the trigger when inserting rivets.
7. Insert the rivet through the predrilled hole in the workpiece.
8. Hold the Riveter rmly with both hands, and squeeze the Trigger (40) to activate
the Riveter. Repeat as necessary. Then, release pressure on the Trigger.
9. When nished using the Riveter, turn off the air compressor. Squeeze the Trigger
again to release any compressed air in the Riveter. Disconnect the air hose from
the tool. Then, store the Riveter in a clean, dry, safe location out of reach of chil-
dren.