Product manual

Page 3For technical questions, please call 1-800-444-3353.Item 68115/69073
Setup
TO PREVENT INJURY:
Wear heavy-duty work gloves and ANSI-approved safety goggles
during setup and whenever handling the Hole Saws.
1. Select the desired size Hole Saw and
either the Large or Small Mandrel.
2. The correct size Mandrel will t
exactly into the Hole Saw.
3. Unthread the Mandrel Nut from
the back of the Mandrel.
4. If needed, move the Pilot Drill Bit
to the selected Mandrel:
a. Remove the Mandrel Nut
from both Mandrels.
b. Loosen Set Screw on the Mandrel
with the Bit using the Hex Key.
c. Remove Pilot Drill Bit.
d. Insert it fully into the other Mandrel.
e. Tighten Set Screw to secure the Bit.
5. If the hole saw you are using has
three holes, use a Drive Plate
on the back of the Hole Saw.
6. Insert the Mandrel through the center of
the Hole Saw and Drive Plate (if used),
and secure in place using the
Mandrel Nut.
Make sure the Hole Saw is held
securely by the Mandrel Nut;
if not, the wrong Mandrel/
Drive Plate may have been used.
7. Open Jaws of Drill Chuck
(sold separately).
8. Place the Mandrel Shaft
completely into the Chuck and
securely tighten the Chuck.
Large
Mandrel
Set
Screw
Hole
Saw
Pilot
Drill Bit
Drive Plate
(some saws)
Mandrel
Nut