Specifications Capacity Height Range (Approximate) 3 Tons (6,000 lb.)* 11-3/16" – 16-3/8" *Evenly distributed across two Jack Stands. IMPORTANT SAFETY INFORMATION Failure to heed these markings may result in personal injury and/or property damage. 1. Study, understand, and follow all instructions before operating this device. 2. Do not exceed rated capacity. 3. Use only on hard, level surfaces. 4. Center load on saddle. 5. Use as matched pair to support one end of a vehicle only. 6.
CAUTION! Be alert to pinching hazard when lowering the Post. 3. Post To secure the Post, tighten the Screw (5) shown in Figure 2. Pawl (not shown) Screw (5) Handle Base Figure B WARNING! Before using the Jack Stands, make sure Figure A the Post cannot be pulled up and out of the Base. 4. Repeat Steps 1 through 3 with the other Jack Stand.
Maintenance and Servicing Parts List and Assembly Diagram Part Procedures not specifically explained in this manual must be performed only by a qualified technician. 1 2 3 4 5 6 7 TO PREVENT SERIOUS INJURY FROM TOOL FAILURE: Do not use damaged equipment. If abnormal noise or vibration occurs, have the problem corrected before further use. 1. Periodically clean the bottom of the Bases and top of Posts of any dirt, grease, or debris. 2. Before each use, inspect the general condition of the Jack.