Table of Contents Safety Safetye��������������������������������������������������������� 2 Specifications.............................................. 4 Setup........................................................... 5 Operationa���������������������������������������������������� 7 Maintenancei����������������������������������������������� 9 Parts List and Diagram............................... 10 Warranty.....................................................
Safety Warnings and Precautions Safety General Safety Warnings Read all safety warnings and instructions. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. Save all warnings and instructions for future reference. WARNING! – RISK OF EXPLOSIVE GASES. Working in vicinity of a lead-acid battery is dangerous. Batteries generate explosive gases during normal battery operation.
Service Have your Power Pack serviced by a qualified repair person using only identical replacement parts. This will ensure that the safety of the Power Pack is maintained. Safety Power Pack Safety Warnings 1. Lead-acid batteries generate hydrogen gas when charging. Hydrogen gas is explosive. Only use the Jump-Start system in a well-ventilated area. 2. Jump-Starting A Vehicle a. Use the Power Pack for jump-starting a LEAD-ACID battery only. b. For emergency use only.
Setup - Before Use: Read the entire Important Safety Instructions section at the beginning of this manual including all text under subheadings therein before setup or use of this product. Functions Work Light Clamp Power Switch Voltmeter Positive Battery Cable Negative Battery Cable Assembly Safety Note: For additional information regarding the parts listed in the following pages, refer to Parts List and Diagram on page 10.
Charging the Power Pack WARNING! Always charge on a non-flammable surface. Safety Press and hold the Battery Test Button on the front of the unit to check the battery power level. a. 13-15 volts is ready for use. b. 12 volts needs to be charged. c. Less than 12 volts should be charged immediately. Turn the Clamp Power Switch on front of unit to the OFF position. Note: Before initial use, completely charge the Power Pack.
DC Appliance Compatibility The lower the amount of watts the appliance draws, the longer the Power Pack can run/charge it before needing to be recharged. Calculate the total wattage needed to run the appliance before operation. You do not need to calculate startup or surge wattages. To calculate the size of the load you plan to use with the Power Pack, use the following formula: Amps x Volts = Watts The actual power usage may vary based on the model or brand of the appliance.
Operating Instructions Using the Work Light Safety 1. To turn the Work Light on, press the Work Light Switch. 2. To turn the Work Lights off, press the Work Light Switch again. Jump-Starting a Vehicle Note: Read the vehicle owner’s manual pertaining to jump-starting prior to using the Power Pack. WARNING! DO NOT CONNECT TO THE NEGATIVE TERMINAL OF THE BATTERY. 1. Press the Battery Test Button to verify that the Power Pack is fully charged.
Maintenance and Servicing Safety Procedures not specifically explained in this manual must be performed only by a qualified technician. To prevent serious injury: Unplug the Power Pack, turn the Power Switch off and allow Power Pack to cool completely before performing any inspection, maintenance, or cleaning procedures. 1. BEFORE EACH USE, inspect the general condition of the Power Pack. Check for: • loose hardware, 2. Keep unit clean and clamps free of dirt, debris, or grease. 3.
Parts List and Diagram PLEASE READ THE FOLLOWING CAREFULLY Safety The manufacturer and/or distributor has provided the parts list and assembly diagram in this manual as a reference tool only. Neither the manufacturer or distributor makes any representation or warranty of any kind to the buyer that he or she is qualified to make any repairs to the product, or that he or she is qualified to replace any parts of the product.
23 Item 38391 For technical questions, please call 1-800-444-3353.
Limited 90 Day Warranty Harbor Freight Tools Co. makes every effort to assure that its products meet high quality and durability standards, and warrants to the original purchaser that this product is free from defects in materials and workmanship for the period of 90 days from the date of purchase.